1988 Brewer 44 Pilothouse Cutter

$74,900

Request Info

PRICE REDUCTION ..  OWNER MOTIVATED ! Designed by Ted Brewer and built by Mao Ta (Taiwan), 'Yankee' , our Brewer 44 Pilothouse Cutter #13 of 15 rare Brewer pilothouse/ deck salon cutters built.   She has a comfortable  3-cabin deck salon design with a spacious and light pilothouse with 280 degree visibility for cruising and features a lower helm station. Her decks are flat with wide side decks, a protected center cockpit and an aft deck.     The 1st owner of 'Yankee' kept her in fresh water on Connecticut River for 10 years. Her current owner purchased  'Yankee' in 1999 and cruised the Atlantic Coast, the Bahamas and the Florida Keys, living aboard for six years before settling in the Tampa Bay Area. 'Yankee' recently had a new bottom restoration which included a peel and  is berthed in Saint Petersburg. Her features include: Raised Deck / Pilothouse design (Hull # 13 of 15 Built) Upper & Lower Helm Stations Taiwan Tongue & Groove Teak interior w/ 6'2" headroom throughout Two Staterooms  & Two Vacuflush Head-Showers   Two reverse cycle A/C units (non functioning) Spacious, well appointed Galley 66hp Yanmar 4JH-HTE TurboDiesel SPECTRA 15 GPH Watermaker 'Yankee' is a rare and spacious blue-water vessel requiring updates through-out and owner is motivated to sell.   All offers considered !

BASIC BOAT INFO

  • Price - $74,900.00
  • Make - Brewer
  • Model - 44 Pilothouse Cutter
  • Year - 1988
  • Condition - Used
  • Category - SAIL
  • Construction - Fiberglass

DIMENSIONS

  • Length - 44 ft
  • Length Overall - 35 ft
  • Beam - 12.92 ft
  • Max Draft - 5.5 ft

ENGINES / SPEED

    ENGINES: 1

  • Make - Yanmar
  • Model - 4JH-HTE
  • Type - Inboard
  • Year - 1988
  • Drive Type - Direct
  • Engine Power - 66
  • Engine Hours - 3050
  • Propller Type/Material - 3 Blade, Bronze

TANKS

  • Fuel Tanks : 1
  • Fuel Tank Capacity : 200|gallon
  • Water Tanks : 1
  • Water Tank Capacity : 135|gallon
  • Water Tank Material : Stainless Steel
  • Holding Tanks : 1
  • Holding Tank Capacity : 40|gallon
  • Holding Tank Material : Stainless Steel
Accommodations

'Yankee' was built using beautiful Taiwan tongue and groove teak panels throughout. She sleeps 8 owners and guests in two staterooms and two heads with showers. 

Main salon: 

U shaped dining table seating for four comfortably at the portside wheel house salon. 

The salon is well lit with three opening ports on starboard and two on port. An entertainment center, with stereo am/fm/cassette/tape player and remote control is hardwired by the starboard settee.

The entire interior is finished in satin varnished matched grain teak. Most of the interior is solid teak planks (not veneer). The settee converts into a full width berth.

Opposite the u-shaped dinette is the settee where the back folds up to make a berth. The cabin sole is satin finished teak and holly.

There is 280 degree visibility through large upper salon windows, keeping guests and owners out of the elements. The pilothouse helm station has with full and complete instrumentation.

To starboard, aft of the helm is a settee that converts into a bunk and accommodates a portable customized "snack table", increasing dinner accommodations from  4 to dinner for 6. The companionway stairs are extra wide with a custom wet locker below.

There is 6 '2" headroom throughout.

Master stateroom:

Highlights include centerline queen berth. This stateroom is well ventilated with opening ports and deck hatch. It is well lit with natural lighting from deck prisms and the master stateroom also has its own 9000 BTU reverse cycle A/C unit. (original)

Forward Guest stateroom:

This comfortable cabin has a double berth with an ensuite head. There is a 16000 BTU reverse cycle AC unit (original) for the Forward cabin and Main salon with separate condensing units. There is a large overhead opening deck hatch offering ample natural light and ventilation. Storage is found in a hanging locker aft and lockers to port and starboard.

  • Two separate VacuFlush head systems, complete (redundant) pumps and holding tanks with optional discharge.  The Master Stateroom Head also has a very large enclosed shower stall with forced air exhaust.

 

Galley
  • Grunert  5.5 cubic' 110V AC Freezer  plus  a 7.5 cubic'  Refrigerator w/ top and bottom access doors and separate temp controls  (non functioning)
  • Seaward princess 3172 propane stove with three burners oven and broiler
  • Custom exhaust hood and fan located above galley stove top
  • Emerson microwave oven (2015)
  • Pressurized hot & cold fresh water system w/ foot pump for fresh and saltwater at sink 
  • Hot water supplied by 12 gallon s/s water heater 110v and main engine heater

, .

Electronics and Navigation
  • Robertson hydraulic autopilot ( new 2006) - includes hand held remote for on deck operation and features rotational gyroscopic compass and NMEA standard integration.

  • Datamarine link 5000, combination speed, wind and depth sounder with remote in cockpit.
  • Garmin 120 XL GPS at Nav Station
  • Raytheon RL9 LCD radar mounts in cockpit.
  • Hummingbird Fishfinder mounted in cockpit.

  • Ritchie navigator 2000 compasses on pedestal and at lower steering station
  • Uniden Oceanus VHF radio with DSC (2015) .

 

Mechanical / Electrical

1988 66HP Yanmar 4JH-HTE Turbo-Charged Diesel (3050 Hours)  

Recent upgrades include: injector service, exhaust elbow, new turbocharger

Ample engine compartment sound insulation. Engine is very quiet.

  • New Turbocharger  (2017)
  • New Exhaust elbow (2017)
  • Dripless Shaft Seal
  • Three Bladed Fixed

    ________________________________________________________________

  • Newmar 50 amp stainless steel battery charger
  • Battery Banks : (6)  T-105 golf-cart batteries for house power plus (2)  T-105 (6 volt) golf-cart batteries for engine/generator starting bank  (NEW -2016)
  • Battery Monitor
  • Galvanic Isolator
  • (1) 40ft dockside electrical shore power cables (30 amp)

  • (2) 500 GPH Bilge Pumps

The 6.5kw Westerbeke Generator is non-functioning, needing   repair or replacement

 

Rigging and Sails

Vessel is equipped for cruising

  • All Standing Rigging replaced  (2005)
  • Main Sail:   371 sq'  Neil Pryde dutchman  (1999)
  • Genoa: 595 sq' UK yankee cut genoa on pro furl roller furling unit
  • Staysail: 180 sq' UK staysail with club foot, self tending sheet, on pro furl roller furling unit

Nine self tailing winches:

  • (2) Barient primary 28ST winches
  • (4) Barient 21ST winches 3 for halyard, 1 for main sheet
  • (2) Barient secondary 24ST winches
  • (1) Barient 17ST winch

Lines for main halyard, boom yang, furling lines and 2 reefing lines return to cockpit. Double ended main sheet cleats behind helm and runs to winch in front of cockpit for easy adjustments by captain or crew. (running rigging needs updating)

Assortment of winch handles one locking handle one non locking

Hull / Deck / Ground Tackle
  • Vessel hauled in May 2018 for major bottom job including peel and was re-launched in December 2018
  • Large custom cockpit dodger and bimini w/ full enclosure sun/screen panels all around (2005)
  • New Bimini (Sunbrella) and New Sail Cover (Sunbrella) (2017)
  • Custom anchor davit w/ rollers for 2 offset anchors
  • Windlass: 3000 lb Maxwell/Nilsson v3000 windlass with foot switch (rebuilt 2010)
  • Eight SS Dorades
  • Anchors:   Primary 88 lb. Delta with 3/8 chain (200ft) and rope/chain windless, Secondary 44 lb Bruce with 200 ft. nylon rope.
  • Ding Davits: (2) Simpson heavy duty polished stainless steel davits for dinghy, each rated for 1000 lbs.
  • Deck box for (2 ) 20 lb. (standard size) propane bottles 
  • Original Teak Deck -  covered and sealed  with 4 coats of Epoxy and 4 coats of Polyurethane 
  •  Winslow 6 person Life raft  (needs recertification)

 

Disclaimer
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.customContactInformation

For additional information and to arrange a viewing please contact Jim Clark, Central Listing Broker  at  (727) 692-1712 or via email at jim@fillinghamyachts.com.

You can also contact Robert Siviter Direct: (727) 415-4676 or by email at robertsiviter@fillinghamyachts.com or visit our website, www.fillinghamyachts.com. 

 Fillingham Yacht Sales, Inc. gladly cooperates with other yacht brokers on a 50/50% basis for our vessels available for co-brokerage.